About dust suppression technology: 4 reasons DustBoss is the way it is

old-fashioned dust control

Back in the olden days, folks suppressed dust using hoses and sprinklers.

One was made for irrigation and the other for putting out fires.

And both are really good at what they were originally intended for: providing maximum water flow.

In the last few years, a lot of thought has been given to dust. The first products developed specifically for dust suppression are based off a few principles in making regulatory compliance easier and more economical.

DustBoss atomized mist technology was developed specifically with dust suppression in mind.

Here are four reasons DustBoss technology is the way it is:

1. Smaller water droplets are more effective at airborne dust suppression

To atomize a substance is to convert it into very fine particles or droplets. Atomized mist technology uses special atomizing nozzles to fracture the stream into millions of fine droplets of water.

So what’s the big deal?

It all comes down to the Slipstream Effect. In order to actually catch fugitive dust in the air and bring it to the ground, the water droplet and dust particle need to be roughly the same size.dust suppression explained

If the droplet is larger than the dust particle, the dust particle has a tendency to follow the airstream around the drop. If the diameters of the water droplet and dust particle are comparable, the dust particle is more likely to collide with the droplet, driving the dust to the ground.

droplet size of dust control methods

Just how big?

A rain storm can generate droplets in the 2,000 to 6,000 micron range and industrial sprinklers can achieve ever greater than that.

In addition, the larger water droplets can disturb the dust on the ground, creating more fugitive dust.

Atomized mist disperses droplets in the 50 to 200 micron range, the ideal range to capture airborne dust.

2. With enough moisture, you can also prevent fugitive dust

 

Hoses and sprinklers can wet surfaces to prevent dust (surface suppression), even if they use a lot more water than is necessary.

Fog systems generate even smaller droplets than mist and may actually be required in certain circumstances. However, in addition to being high maintenance and expensive, often requiring distilled water, compressed air, and highly control conditions, fog systems do not use enough moisture to create any residual benefit on surfaces.

Atomized mist is the only technology that can both drive airborne dust particles to the ground and seal the surface to prevent fugitive dust.

3. Small water droplets + enough water = incredible coverage.

 

atomizing nozzles

Smaller droplets have the potential to travel farther because of the higher ratio of surface area to mass, which means the influence of air pressure compared to gravity is relatively greater. Therefore, the air will keep them aloft longer before gravity brings them down.

Atomized mist is the only technology that can both drive airborne dust particles to the ground and seal the surface to prevent fugitive dust.

In other words, heavier water droplets will fall victim to gravity quicker. We see this in clouds. When water droplets grow too large, they fall as rain.

Smaller water droplets can be more prone to evaporation, which is why you need the right nozzle for your situation. This may actually be the desired effect depending on your situation.

Fog cannons are simply incapable of significant coverage due to evaporation. Remember when we said fog systems require controlled conditions? Ideally, this means enclosed, with no wind movement. Fog must linger in the air, undisturbed, to slowly bond to dust particles.

Pairing atomizing nozzles with an aggressive fan can help droplets power through air resistance, achieving coverage up to just under five American football fields with one unit (DB-100 with oscillation).

Mounting a DustBoss on a tower can increase coverage even more, in addition to improving overall effectiveness.

4. At a certain point, more water won’t improve dust control and can create problems.

 

Water usage for sprinklers, hoses, and mist

It’s the Goldilocks dilemma: What is just right?

In terms of dust suppression, the DustBoss delivers enough water to cover large areas and seal surfaces, but not more than necessary.

Not only is mist more effective than sprinklers, the DustBoss uses up to 21 times less water.

You can set out to save money and end up spending more in the long run with old-fashioned dust suppression methods. But the benefits go beyond just the flat dollars saved on the water itself.

water conservation

With atomized mist, you get:

  • More strategic water usage and lower associated cost.
  • Reduced storm water effects and runoff, critical in keeping air and land pollution in balance.
  • Fewer pools of water to ensure a safer and more efficient worksite.
  • Avoided product oversaturation, often creating a muck that is difficult to handle and sticks to facility surfaces and equipment, shortening the life of both.